Why It Keeps Clicking
Wolf sealed burners use a spark igniter that should stop once the burner lights. When it keeps clicking, the ignition circuit is not seeing a clean, established flame, usually because moisture or spill is bridging the igniter, or the burner cap is off-center and disrupting the flame. The module responds by continuing to spark.
| Symptom | Likely Cause | Fix |
|---|---|---|
| Clicks after lighting | Wet or soiled cap and igniter | Dry and clean, reseat cap |
| Clicks when clean | Cracked igniter | Replace igniter |
| Off-center flame, clicks | Misseated or warped cap | Reseat or replace cap |
| All burners click | Spark module or wiring | Diagnose module |
Dry and Clean Everything First
The most common fix is simple. After a spill, boil-over, or cleaning, water and debris on the cap and igniter keep the circuit firing. Turn the burner off, let everything dry fully, and clean the cap and igniter. Reseat the cap squarely so it sits flat. This stops the clicking in most cases.
A Cracked Igniter
If the burner is clean and dry but still clicks continuously, the ceramic igniter may be cracked. A hairline crack lets the spark leak to the wrong place, so the circuit never registers a stable flame and keeps firing. This is a common wear item and a straightforward replacement that ends the clicking.
Cap Alignment and Spark Module
A burner cap that is warped or set on an angle throws the flame pattern and can keep the igniter clicking. If multiple burners click together, the spark module or its wiring is more likely than any single igniter. A technician checks the caps, igniters and module to find whether it is one burner or the shared circuit.
Wolf Burner Clicking Non-Stop?
Book a visit or call now. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.
Frequently Asked Questions
Why Does My Wolf Burner Keep Clicking After It Lights?
Usually moisture or debris on the burner cap and igniter, or a cap that is off-center, so the spark module keeps firing. Drying and cleaning the cap and igniter and reseating the cap squarely stops it in most cases.
How Do I Stop a Wolf Igniter from Clicking?
Turn the burner off and let the cap and igniter dry fully, then clean them and reseat the cap flat and square. If it still clicks when clean and dry, the igniter is likely cracked and needs replacing.
Is Constant Clicking Dangerous?
It is not immediately dangerous if the burner is lit, but a burner that keeps sparking or will not light cleanly should be addressed, since it can indicate a cracked igniter or a cap that is disrupting the flame. Turn the burner off if it will not light and clicks continuously.